Cobra CR6 Specifiche Pagina 1

230636-11 For use in GB & IE Static Oven Range Models: CR6 (600mm) CR9 (900mm) INSTALLATION AND OPERATION MANUAL

8 Part 3 Installation Commissioning The following commissioning checks must be carried out before the Range is handed over for use, to ensure th

9 Part 4 Operation 2. Improper operation is therefore almost impossible, however bad operation practices can reduce the life of the appliance and p

10 Part 4 Operation d. The pilot should now remain alight - if not, repeat Steps (a. to (c. above. e. ‘Full Flame’ can now be achieved by depressin

11 Part 4 Operation - Main Burner / Thermostat 1. With the pilot burner alight, rotate the oven thermostat control knob to the desired oven temper

12 Part 5 Cleaning and Maintenance CORRECT LEVEL FOR FRYING MEDIUM WHEN AT FRYING TEMPERATURE, KEEP TOPPED UP INDICATES CORRECT FRYING MEDIUM LEVEL W

13 Part 5 Cleaning and Maintenance Trivets and Burners a. Remove the trivets from the top of the appliance, taking note that the trivets are manuf

14 Part 5 Cleaning and Maintenance Gas Control Valve Re-Greasing The gas control valve should be dismantled and greased every 6 months to ensure the

15 Part 6 Gas Conversion Gas Conversion Procedure NOTE:  These conversions should only be carried out by qualified persons. All connections must b

16 Part 6 Gas Conversion Griddle 1. Carry out the following:-  Remove griddle plate section and heat shield.  Remove main burner.  Disconnect

17 Part 6 Gas Conversion Low Fire Adjustment 1. To change the thermostat ‘Low Fire’ screw for the gas type required, remove the following:-  Gas c

The reproduction or copying of any part of this manual by any means whatsoever is strictly forbidden unless authorized previously in writing by the ma

18 Part 6 Gas Conversion Gas Specifications - Australia - New Zealand NOTE: * Measure burner operating pressure at manifold test point with two b

19 Part 6 Gas Conversion - United Kingdom Category: II2H3P. Flue Type: A1. NOTE: * Measure burner operating pressure at manifold test point w

20 Part 6 Gas Conversion - All Other Markets NOTE:  (*) Measure burner operating pressure at manifold test point with two burners operating at &ap

21 Part 7 Replacement Parts List Replacement Parts List When ordering spare parts, please quote the part number and the description as listed below.

22 Part 7 Replacement Parts List Oven 022446 Oven Burner (CR6). 230441 Oven Burner (CR9). 235493 Eurosit Gas Control Valve. 228836 Max Rate Screw

Contents CR6 Gas Static Oven Ranges (600mm Wide). CR9 Gas Static Oven Ranges (900mm Wide). Part 1 Introduction ...

We are confident that you will be delighted with your Cobra Series Ranges, and it will become a most valued appliance in your commercial kitchen. To

3 Part 2 Specifications The CR6 Oven is a 490mm (internal) full width oven fitted with French style opening doors. The oven burner is a 24-26 MJ ove

4 Part 2 Specifications - United Kingdom: NOTE: (*) Measure burner operating pressure at manifold test point with two burners operating at full sett

5 Part 2 Specifications Gas Connection CR6 Model Gas supply connection point is located at the rear of the appliance, approximately 130mm from the ri

6 Part 3 Installation Location 1. This appliance must be installed in a suitably ventilated room to prevent dangerous build up of combustion produc

7 Part 3 Installation Regulator outlet pressure is fixed ex-factory for the gas type that the regulator is converted to and it is NOT to be adjusted.